In a display faster than 0.2ms or so, the on/off cycle is more than one screen, so it’d just (very incorrectly) look like a flat line. Unfortunately, the PWM on this light is so bad that it doesn’t even work with my normal scale, which is 50 microseconds (50us). I’m adding multiple timescales, so it’ll be easier to compare to the test light. Also, here’s the light with the worst PWM I could find. When charging is complete this LED turns green.įor reference, here’s a baseline shot, with all the room lights off and almost nothing hitting the sensor. When charging, a LED beside the charge port is red. I am not able to log charge cycles for this type of connector, but a couple of tests indicate it charges fully in around 2 hours to 2h 15m. So just plan to use this wall wart (which is included, anyway.) This has the same specifications as the Imalent DX80 wall wart, but the DX80 didn’t seem to have exactly the same plug as this one and wouldn’t work for this light. There’s a charge port in the tail end, covered by the metal disk we talked about above. That’s expected and is also a testament to how much cooling they are providing. You can see what happens when the fans go off, too – the temperature shoots up a bit. The light does shut off when voltage is low, and when the light shuts off so do the fans. The MS12 Mini runs on a “4000mAh 21700 Li-ion battery pack” which ships covered with this little plastic shield. The light can’t be used while in the pouch. This pouch allows only one-direction installation, and the tailcap hangs out the bottom. If installed improperly, the light won’t tailstand properly any more.īut if you install the lanyard/wrist strap as seen below, you can still tailstand properly.Ī nylon pouch is also included. Either way, it can connect to the tailcap as seen below. Two ways are included for carry of the MS12 Mini. Try not to get buried in the details of manufacturer specifications versus measurements recorded here A certain amount of difference (say, 10 or 15%) is perfectly reasonable. I use hobbyist-level equipment for testing, including some I made myself. ^ Measurement disclaimer: Testing flashlights is my hobby. Long Review The Big Table Imalent MS12 Mini Flashlight The fans seem effective, and the Imalent MS12 Mini flashlight can hold high output for quite some time. Output on this model is great and very high for a little while before stepping down. The MSRP and the going price for the MS12 Mini is $409.95.įirst of all, the integrated fans are a big improvement over the heat shroud used in a few previous models. On the page, I see Cree XHP70.2 (seen in this review), Cree XHP70.3, and a warm Cree XHP70.2. There are apparently three emitter options, though. This is the only version of the Imalent MS12 Mini flashlight. Here’s a link to the Imalent MS12 Mini flashlight product page. Imalent has released the MS12 Mini, a flashlight featuring 12 Cree XHP70.2 emitters and three built-in cooling fans. Tint vs BLF-348 ( 219b version) (affiliate link).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |